Single-row housing
The A1015 housing drawing specifies a red Nylon 46 body and a 1.00 mm contact pitch.
Confirm your configuration
A1015 connector series
A1015 is a 1.00 mm connector system. Compare the drawing-based specifications and construction options below, then identify the required configuration for quotation.
Connector construction
Compare configuration options
Select the housing, contacts and mating connector together. The available circuit counts and materials depend on the specific drawing, rather than one range covering every variant.
Mating assembly
The accompanying terminal and board pages carry a separate series identity. Select them against the A1015 housing requirements, not as an unrestricted set of A1015 variants.
Specifications
Technical Specifications
Dimensions, materials and electrical ratings are configuration-specific. Refer to the corresponding technical drawing for part selection.
| Parameter | Specification |
|---|---|
| Pitch | 1.00 mm |
| Drawing-reference current | 1 A AC/DC |
| Drawing-reference voltage | 200 V AC/DC |
| Temperature range | -25 to +85 °C |
| Overview wire reference | 28–32 AWG |
Drawings
A1015 Technical Drawings
View the drawings below or open the original PDF. Dimensions and specifications apply to the configuration and revision shown.
A1015 Technical Drawings
Engineering response
Need a review of A1015 connector series?
Send the released drawing, target configuration, quantities and any required documentation so the technical team can confirm the next step.